|
01-23-2004, 04:22 PM
|
#1 |
|
registered IWATA user
Join Date: Feb 2002
Location: Baton Rouge
Posts: 4,481
|
startup procedure?
my 71 is mostly back together, i need to start it and take it for a drive. its been sitting for four weeks or so, and i cant get power. i'm going to get the battery tested. i'm changing the oil and maybe going to clean the carb. anything else important that i am missing?
__________________
-'63 Ford Fairlane 500 coupe, v8, auto, faded and rusty. awaiting built roller 302 and some flat black -'99 Honda Prelude. vtech/5spd. no pipe, no intake, bone stock. awaiting new top end. -01 GMC Yukon SLT 5.3 dented and scratched with a noisy tranny. Take off that Von Dutch hat before i stab you with a 000 Mack. |
|
|
|
01-23-2004, 05:02 PM
|
#2 |
|
registered IWATA user
Join Date: Feb 2002
Location: Baton Rouge
Posts: 4,481
|
drained the oil, there was a little water in it, oh crap.
__________________
-'63 Ford Fairlane 500 coupe, v8, auto, faded and rusty. awaiting built roller 302 and some flat black -'99 Honda Prelude. vtech/5spd. no pipe, no intake, bone stock. awaiting new top end. -01 GMC Yukon SLT 5.3 dented and scratched with a noisy tranny. Take off that Von Dutch hat before i stab you with a 000 Mack. |
|
|
|
|
01-23-2004, 09:40 PM
|
#3 |
|
67-72 truck surgeon
Join Date: Jul 2003
Location: Indiana
Posts: 155
|
The water in the oil might be from something simple like having a leak in the intake gaskets. Check compression on every cylinder to make sure a head gasket isn't blown. Good luck.
__________________
1969 Chevy C10 1993 Toyota Camry LE 1999 Ford F250 Super Duty 4x4 diesel 2008 Dodge Charger Super Bee 1953 International R182 |
|
|
|
|
01-23-2004, 10:26 PM
|
#4 |
|
Registered User
Join Date: Jan 2003
Location: Washington State
Posts: 8,831
|
Don't forget some fresh gas..............
__________________
1970 Chev CST 2003 Harley Fatboy 1975 Chevrolet Step Van 1956 Chev Bel Air 1977 Blazer 2WD For Sale $3000.00 1978 Blazer 2WD For Sale $7000.00 1978 Silverado 2005 Monte Carlo |
|
|
|
|
01-24-2004, 01:18 AM
|
#5 |
|
registered IWATA user
Join Date: Feb 2002
Location: Baton Rouge
Posts: 4,481
|
changed filters, oil, fuel filter, cleaned carb, and checked plug gap. the problem is electrical. turn the key, nothing happens. no lights, no power to starter. i put the voltmeter on everything under the hood and have power, but nothing inside gets juice, so the problem must be at the fuse block. i'll figure it out tomorrow
__________________
-'63 Ford Fairlane 500 coupe, v8, auto, faded and rusty. awaiting built roller 302 and some flat black -'99 Honda Prelude. vtech/5spd. no pipe, no intake, bone stock. awaiting new top end. -01 GMC Yukon SLT 5.3 dented and scratched with a noisy tranny. Take off that Von Dutch hat before i stab you with a 000 Mack. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
