The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Engine & Drivetrain > LSx Swaps

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 01-04-2016, 11:18 AM   #1
clemsonteg
Registered User
 
Join Date: Jul 2012
Location: Anderson,SC
Posts: 953
Replacement parts before install

So I picked up a 5.3 which supposedly had 140k on it, but after some digging I was able to decode partial vin stamped into the block and determined that it had closer to 190k on it. I pulled the valve covers and it looks clean, and I know that the truck was running and driving since it was pulled due to a collision. What parts should I look at replacing before I install the motor?

I was thinking of the water pump and oil pump. Should I upgrade the oil pump, even if I used a factory replacement? I already plan to replace gaskets to parts I am removing to paint the motor (intake, valve covers, exhaust manifolds). Anything else I should do before I put the motor in the truck?
clemsonteg is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 11:18 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com