|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-20-2007, 06:52 PM
|
#1 |
|
Senoir Member
Join Date: Mar 2002
Location: Rock Hill, SC USA
Posts: 1,214
|
Replacing vent glass question....
How do you remove the old glass from the vent window frame? I need to rechrome the frame then install new glass. Any help on removing or installing the vent glass would be nice. I have new glass setting rubber tape or whatever you call it. Thanks
__________________
67 Chevy, Small back glass, Factory 4WD, Factory Shortbed, Factory V8, Lifted 4" 70 GMC Sierra Grande, Factory Shortbed, Factory 402/400 turbo, Super Custom Interior. Numbers matching with SPID & Build Sheet. 68K Original Miles. Restored 2010 70 GMC Restoration Pictures http://67-72chevytrucks.com/gallery/...00&ppuser=4424 |
|
|
|
05-20-2007, 08:24 PM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Replacing vent glass question....
I wet the glass/rubber down with a soap solution and then pull the glass out starting at the top. Sometimes I have had to pry the glass out out using a smooth screw driver with rounded edges to get the glass started out.
On installing the glass I apply the tape to the glass, soap it down and then pound it into the frame with a rubber hammer. Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
