quarter panel help in wa - The 1947 - Present Chevrolet & GMC Truck Message Board Network

vtblazer · 09-24-2007, 06:30 PM

2nd, be cautious about posting a wanted to buy thread without being a subscribing member.

The mods will lock it up.

Check out some of the vendors to see if they might sell a patch panel that will take care or it.
Might be the easiest way to go.

**jaros44sr** · 09-24-2007, 07:18 PM

Patch panel is the easiest way to go, I have one on both sides of my Jimmy and they are not that hard to put in. Are saying the area by the door or by the bumper?? Can you weld? J.

**Classic Bowties** · 09-25-2007, 12:08 PM

Quote:

Originally Posted by vtblazer

2nd, be cautious about posting a wanted to buy thread without being a subscribing member.

The mods will lock it up.

Check out some of the vendors to see if they might sell a patch panel that will take care or it.
Might be the easiest way to go.

vintagechevy76: Welcome to the board and

, should you decide to support the board and go Blue feel free to drop me a pm. I am in the PorTland, OR. area only a short drive from Castle Rock, I could probably help you out with a complete (door to taillight) blazer bedside. Cb

LUV2XCLR8 · 09-26-2007, 04:17 PM

Quote:

Originally Posted by Classic Bowties

I could probably help you out with a complete (door to taillight) blazer bedside. Cb

Better jump all over that

vintagechevy76 · 09-27-2007, 04:10 AM

already done. Just waiting on some more info.

09-24-2007, 06:30 PM	#1
vtblazer Registered User Join Date: Oct 2003 Location: Central Vermont Posts: 8,537	Re: quarter panel help in wa 2nd, be cautious about posting a wanted to buy thread without being a subscribing member. The mods will lock it up. Check out some of the vendors to see if they might sell a patch panel that will take care or it. Might be the easiest way to go.

09-24-2007, 07:18 PM	#2
jaros44sr Senior Member Join Date: May 2006 Location: Philadelphia, Pa. 19454 Posts: 9,855	Re: quarter panel help in wa Patch panel is the easiest way to go, I have one on both sides of my Jimmy and they are not that hard to put in. Are saying the area by the door or by the bumper?? Can you weld? J. __________________ Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim Last edited by jaros44sr; 09-24-2007 at 07:19 PM.

09-27-2007, 04:10 AM	#5
vintagechevy76 Registered User Join Date: Aug 2007 Location: Castle Rock, Washington Posts: 37	Re: quarter panel help in wa already done. Just waiting on some more info.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.