|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-22-2010, 08:37 PM
|
#1 |
|
Registered User
 
Join Date: Dec 2008
Location: Providence Rhode Island
Posts: 404
|
pressing in control arm bushings
What is the best way to press in the lower control arm bushings? I don't have the special c-clamp tool like the old service book shows. I tried to push them through with an impact gun on the nuts of the cross shaft but it only pulls them in so far. Any ideas would be appreciated.
|
|
|
|
07-22-2010, 09:34 PM
|
#2 |
|
Senior Member
Join Date: Feb 2010
Location: Maumelle, AR
Posts: 478
|
Re: pressing in control arm bushings
I just bring em to a machinist and have him press them in with a hydraulic press
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
