![]() |
![]() |
#5 |
Registered User
Join Date: Mar 2003
Location: San Francisco, CA USA
Posts: 2,454
|
Re: Old vs new front end
This isn't 100% guaranteed, because you can get some oddball tie rod ends if you look hard enough, but it will work if the builder used stock parts. Measure the thread diameter (at the adjusting sleeve) on the outer tie rod ends, Factory disc brake spindles will be 11/16". Aftermarket conversion spindles will be 5/8" because they use the stock early tie rods.
Ray
__________________
Live more responsibly. Eat lower on the food chain. Eat vegetarians. Last edited by raycow; 11-16-2010 at 07:10 AM. |
![]() |
![]() |
Bookmarks |
|
|