The Fuse is Lit...

[usmcchevy]

looking good, What did your driveshaft come from?

[RocketKing]

Originally Posted by 67chevy1series

sharpie is the man!!!!!!!!!!!!!!

Yes...yes he is!!

Originally Posted by usmcchevy

looking good, What did your driveshaft come from?

Actually, I don't know. A buddy had a driveline at his shop and we knew the yoke was close to the right size. I took it home and the yoke slid in.
His best guess was that it is from a early 90's Chevy truck big block which, he said, have the 400 turbo behind them, I have also read that Muncie 4 speeds also have the same 32 spline as the 400.
I do not know this as fact so take it with a grain of salt (I read it on the internets so it must be true!!) I had to have the 400 because my tranny is the 4l80e. I think the 4l60 take the 350 yoke.
I have my motor mounted in the 6 cyl position, if it were in the 8 cyl position it would perhaps bolt in, here are some pics.

[67chevy1series]

might as well take it off and give it tome

[RocketKing]

Originally Posted by 67chevy1series

might as well take it off and give it tome

Lol, no kiddin', what are the chances of just finding a driveline laying around that happens to fit your build. Will be a real blessing if it works out.

[67chevy1series]

yes a drive line will be hard to find for me

[usmcchevy]

Originally Posted by 67chevy1series

yes a drive line will be hard to find for me

Yep, same here. At least my motor and trans came with the output yolk and hopefully I can just have my stock drive shaft shortened. I do plan on once I get the motor and trans in measuring what I need and calling a few salvage yards, maybe I'll get lucky.

[67cheby]

you dont have an extra drivers vent like the one you got from Sharpie do you ??