|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-08-2012, 02:06 PM
|
#1 |
|
Registered User
 
Join Date: Mar 2005
Location: apple valley, ca
Posts: 2,670
|
A-arm clearance when running 15" wheels
How much do you have to grind off the control arm when you run a drop spindle (I've got Bell Techs) and stock 6" or 7" wide 15-inch stock steel wheel? A little or a lot?
Or...CAN you run a skinny front 15" steelie with dropped spindles? I'm going for a particular look on my '64, and I need to know what I have to do.
__________________
Check out my latest endeavor: https://roundsixpod.com My build threads: '55 Chevy: http://67-72chevytrucks.com/vboard/s...d.php?t=247512 '64 C-20: http://67-72chevytrucks.com/vboard/s...d.php?t=446527 |
|
|
|
01-08-2012, 02:39 PM
|
#2 |
|
Registered User
Join Date: Mar 2006
Location: Pittsburgh
Posts: 1,694
|
Re: A-arm clearance when running 15" wheels
I only had to grind a very little bit of the lip around the ball joint on my 72 C10 with bell tech spindles and 2" drop coils. I was running 15"x8" aluminum wheels though so you may be OK with the stock steel wheels.
I'm sure others will chime in.
__________________
Nate 1967 short fleet Project Blue Goose 'If it don't bounce back... heeheehee you go hungry!" Blues Brothers |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
