Not Another Rebuild Thread....

[joe231]

Upper and lower balljoints (2 of each)
Upper and lower control arm bushings (4 of each)
Inner and outer tie rod ends (2 of each)
Pitman arm and idler arm (1 of each)
Rotors, inner and outer bearings and races (2 of each and you will need to know if you have 1 inch thick or 1.25 inch thick rotors)
Calipers (1 left and 1 right)
Brake pads and hardware
Front brake hoses (left and right)
Sway bar bushings (4 of each and you will need to know the bar diameter)
Coil springs (2 of each)

I think that's all you need

Also, you probably know this already...
You don't have to swap the crossmember.
You can use everything on your current crossmember.
Posted via Mobile Device