does anyone run 1/2 inch push fittings on 200 psi? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

jimmydean · 07-06-2012, 01:11 PM

I did 1/2" on my '69 and it was TOO fast. I ended up putting dump and fill adjusters to control the flow. It was nice to be able to dial it in, but I will do 3/8 max from now on.

king-918 · 07-06-2012, 01:36 PM

Quote:

Originally Posted by jimmydean

I did 1/2" on my '69 and it was TOO fast. I ended up putting dump and fill adjusters to control the flow. It was nice to be able to dial it in, but I will do 3/8 max from now on.

i was thinking if its too fast i would just keep reducing the dump? you 1/2 to 3/8 or 1/4.

07-06-2012, 01:11 PM	#1
jimmydean Registered User Join Date: May 2005 Location: Beaverton, OR Posts: 3,728	Re: does anyone run 1/2 inch push fittings on 200 psi? I did 1/2" on my '69 and it was TOO fast. I ended up putting dump and fill adjusters to control the flow. It was nice to be able to dial it in, but I will do 3/8 max from now on. __________________ New Project: 1966 LWB C20 Plans: 1/2 ton conversion Dropmember front Dropmember rear Corvette discs Restored raised bed http://67-72chevytrucks.com/vboard/s....php?p=4295210



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.