Grill swap question

[jonzcustomshop]

Originally Posted by jonzcustomshop

As far as I know 60-63 and gmc use the same mount points.

Ha! I was wrong...just went in the shop, looks like they use the same top 2 mounts, but the lower were different on gmc, chev 60-61, and 63.
I will put my 62 and 63 grilles next to each other when I go out to the yard later today, and get you some exact measurements, you might have to drill a couple holes for the bottom.

luckily the top outer corner mounts are in the same spot on all 60-66, so if needed you can hold any grille in that way, I did that when I ran a 62 grille in my 65 for a few weeks.

[Blue Blood]

Originally Posted by jonzcustomshop

Ha! I was wrong...just went in the shop, looks like they use the same top 2 mounts, but the lower were different on gmc, chev 60-61, and 63.
I will put my 62 and 63 grilles next to each other when I go out to the yard later today, and get you some exact measurements, you might have to drill a couple holes for the bottom.

luckily the top outer corner mounts are in the same spot on all 60-66, so if needed you can hold any grille in that way, I did that when I ran a 62 grille in my 65 for a few weeks.

That's great, at least I have 2 factory holes (no laughing !)to use foe alignment.I should have the grill this weekend.
Posted via Mobile Device

[Blue Blood]

I got the grill today, decent shape & surface rust only, one small dent near the pass. Side headlight. I'm gonna clean it up a bit then hang/mock it up before the truck goes into the body shop (yes !) I am missing the bezels....hint,hint.
Posted via Mobile Device