anyone put 2 1/16 in. gauges in dash

[blazer2007]

Originally Posted by dieseldawg142

unless you can find a gauge that's like an inch thick, (good luck!), you will have to do some trimming. did my 4 small gauges with autometers
you will have to dremel the gauge housing a bit
Attachment 1118934
also have to trim the "glass" & gauge backing
Attachment 1118935
more trimming on the gauge panel
Attachment 1118936
wire them up
Attachment 1118937
and your good to go
Attachment 1118943

would you happen to have a side profile picture of picture #3

[dieseldawg142]

Originally Posted by blazer2007

would you happen to have a side profile picture of picture #3

sorry, no. did the gauges a few yrs ago, was my first attempt at dicking with the wife's digi cam, only took a few. if it's depth to cut your looking for, i just slid the gauges in the hole & started trimming till it looked rite to me. also trimmed them on a bit of an angle to face me. only pic i have of the bezel