Red rebuild

[osaltyone]

Raised the bed floor almost 4" and made a notch cover. I was going to go complete floor, but did not like the way the wheel wells looked at the top of the bed. Did not come out exactly how I planned in my head, but it will do.

Removed all the old roll on bed liner I had in there, then made the patch panels to fill the holes, hit it with seam sealer then sprayed Raptor bed liner in the bed. I think the Raptor is a bit thin, so I ordered another kit and will spray it again.










I ordered a slim compressor since the old one I had was leaking and had 2 ports that leaked because I broke off fittings in them. I built my stand for the new compressors tank and valves. Now have to figure out how I want to mount it in the bed. You can see my old valves and the mess in this pic. Trying to clean it up a bit.





Hate to cover it up with my Tonneau, but think I should.

[mooseknuckles]

nice set up....

[54Caddy]

looking good man! at least one of us is making progress. although I did buy another truck ahahah