McGaughys 63156 Front Disc Brake Kit work with Belltech spindles?

[lolife99]

Originally Posted by zipper

Sorry to thread jack GAc10boy, but I have a question that I feel could be answered in this thread. Currently I have 15's and if I were to use a belltech 3' drop spindles vs a McGaughy 2.5' drop spindle, would the 3' spindle create an issue with rubbing the wheel? Or is the rubbing with 15' wheels everyone talks about just caused by the control arm?

The rubbing is caused by the wheel.
A 15" wheel with more than 3.5" of backspacing and drop spindles.
2.5" and 3" both cause issues.

[zipper]

Originally Posted by lolife99

The rubbing is caused by the wheel.
A 15" wheel with more than 3.5" of backspacing and drop spindles.
2.5" and 3" both cause issues.

So is a 3' any worse than a 2.5' spindle?

[lolife99]

Originally Posted by zipper

So is a 3' any worse than a 2.5' spindle?

Not really.
Either way you need to trim the lower a-arm to provide clearance around the lower balljoint on the a-arm lip.

[GAc10boy]

Originally Posted by lolife99

Not really.
Either way you need to trim the lower a-arm to provide clearance around the lower balljoint on the a-arm lip.

Thanks for all your help here, Keith. You really are a huge asset to this board and the 67-72 community.

[zipper]

Originally Posted by lolife99

Not really.
Either way you need to trim the lower a-arm to provide clearance around the lower balljoint on the a-arm lip.

Thanks for answering man!