T5 Camaro Tailshaft Swap

[Lugnutz65]

Originally Posted by 69rut

You will most likely need to change the speedometer drive gear location on the tailshaft. The gears usually have a clip holding them in place with a hole in the tailshaft as well. You can not drill a new hole and the shaft diameter is smaller where the gear needs to be positioned. Best bet is to shim the gear and use some J-B Weld to hold it all in place.

His 1989 S10 tail shaft housing has a VSS sender. He cannot make the Drive gear work unless he finds an S10 tail housing with cable connection. If he finds one of those, then your advice is correct.