CA WTB Adapter For NP205 to Th400

[4x41971SWB]

Originally Posted by A1971Blazer

OK.......I found it......in very good shape....I bead blasted it a little to get the surface rust off....threads are good

Old seal is still installed in it (needs replaced)

Attachment 1552004

That's some leftover silicone around the holes

Attachment 1552005

Here's the deal..........I was originally going to adapt a 4L60E to my NP205, when I tore the 205 down to rebuild it.....it had several parts that were going to need replaced....so I abandoned it and opted for a 241C.....

I was really hungry for an adapter and I paid way too much for this one.....but......that's water under the bridge......my bad.

AA sells the same adapter for around $260.....it's a reproduction and I'm sure it's a very good quality...I have used their stuff quite a bit....never had any issues....

I looked up your zip (guessed) 92025...? UPS ground ship would be $35.00...

SO....after all that long winded BS.....I will take $250 and I will pay the shipping and PP fees.....at this point I don't have a use for it anyway...

Let me know....thanks!

I`ll Take it as long as its as you describe with all bolt threads in good condition.
Thanks

[A1971Blazer]

Originally Posted by 4x41971SWB

I`ll Take it as long as its as you describe with all bolt threads in good condition.
Thanks

Threads guaranteed to be good.....I will blast it clean all over, run a tap thru the threads to clean them out, and zinc chromate primer it for you......will reply to your PM......thanks...enjoy!

[4x41971SWB]

Originally Posted by A1971Blazer

Threads guaranteed to be good.....I will blast it clean all over, run a tap thru the threads to clean them out, and zinc chromate primer it for you......will reply to your PM......thanks...enjoy!

Payment sent.
Thanks
Chris