The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Engine & Drivetrain > LSx Swaps

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 06-23-2017, 08:57 AM   #9
djhenderlong
Registered User
 
Join Date: Jun 2017
Location: Ann Arbor, MI
Posts: 1
Re: Gen V Engine swap info

I'm currently working on a Turbo 2016 L83 / Powerglide swap and I have a few wiring questions.

1. Is the BCM required if I am not running a stock trans? I believe the answer is no. If that is the case - do I need to loop any data lines in order to trick the ecu that there is a BCM connected?

2. Does anyone have a accelerator pedal pinout? I bought the truck pedal, however the pins are not labeled on the physical pedal (a, b, c, ect).

3. In order to use HP tuners, I need an OBD2 connector. I bought a small connector but I do not see how this is wired into the harness. Does anyone have this pinout?

4. Because I am not running the stock trans, am I correct by saying that I would need to flash the ecu as a manual trans? I have also been hearing that I need to add a jumper wire to the trans output on the harness side. This jumper allows the data lines to be connected to one another. Does anyone have a pinout/diagram of this?

Thanks for all the help,
Dave.
djhenderlong is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:55 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com