![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
Join Date: Apr 2017
Location: Bozeman
Posts: 219
|
Re: Where does a guy start?
Sorry I had to run off and wanted to see a few more things just for my head.
So is the end all be all for big boys to be able to increase/decrease and or manipulate each and every set of frequencies just so they can assign them to the proper driver and or be able to modify them? I get time alignment and the how's and WhYs make since but the latter iam a bit confused over. How deep is the hole? Are these silly boys with 50k in there cars still limited to what snoop dogs engineer was using at the time of the recording lol? What's your realistic interpretations of the gear you want to run? |
![]() |
![]() |
![]() |
#2 | |
Registered User
Join Date: May 2014
Location: ID
Posts: 663
|
Re: Where does a guy start?
Quote:
and spend 3-6 months reading and participating in this forum before you buy anything. There is no rush to buy anything now. Maybe, a head unit if you're going to cut the dash. Everything else can be installed after body / paint. |
|
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Apr 2017
Location: Bozeman
Posts: 219
|
Re: Where does a guy start?
Now I just want to know why more than how lol! But of course you are right! I do not want to buy an osicilscop ever to be honest. Ya ha it's like my twin turbo project to much for my puny little brain. Ok so iam just going to shi# can all this over the top stuff. Unless there's a really good reason not to use Rockford fosgate I think I'll use the ones you recommended and call it good. Maybe when iam ready I'll ask for set up advice too! I've been reading a lot on diyma but it is hard reading ! Not to many noobs around there. Their classified have some good stuff but for now I'll do new just to be safe. I'll buy my helix there in a couple years lol! Thanks my friend you've been a good sport and I appreciate all your time! I'll check back in when iam installing!
|
![]() |
![]() |
![]() |
#4 |
Registered User
![]() Join Date: Oct 2015
Location: Woodbridge Va
Posts: 401
|
Re: Where does a guy start?
Just read through this entire thread and thank you guys for the input. I'm in the same boat, only my ride is much larger. I want my kids to be able to enjoy the music while sitting in the back, but I don't want to break the bank either.
|
![]() |
![]() |
![]() |
#5 |
Registered User
Join Date: Nov 2017
Location: Anthem AZ
Posts: 281
|
Re: Where does a guy start?
@BIGlaSS,
Did i read that you would stay away from a center speaker(s) with the kick panel speaker set up? Or the other option would be to put in two Tweeters in the center speaker opening? I am looking at a 6.5 kick panel speakers 3 or 4 way probably 3 way, a 10" enclosed subwoofer for under the passenger side and a kicker CX 600.1 amplifier with a Retrosound Long Beach Radio as it has a built in Subwoofer output. I have a budget of about $1,000 for this and it fits it. Gas tank still in the cab so i don't have room behind the seat. Will this suffice for some good sound? Any advise please? Im pretty eclectic ( country, Jazz, Pop, Heavy metal too). |
![]() |
![]() |
![]() |
#6 |
Registered User
Join Date: May 2014
Location: ID
Posts: 663
|
Re: Where does a guy start?
Correct. When you don't install mids/tweets in the same location, you will have to use a processor and time delay to tune.
__________________
My museum of good intentions: 1957 3100 BBW restomod -- 1970 442 W30 |
![]() |
![]() |
![]() |
Bookmarks |
|
|