|
08-21-2018, 04:52 PM
|
#1 |
|
Registered User
Join Date: Sep 2016
Location: Lexington, Ky
Posts: 71
|
69/70 hood emblem
Does anyone have measurements for drilling for a 69/70 hood emblem? I have a 71/72 hood and want to add the emblem.
Posted via Mobile Device |
|
|
|
08-22-2018, 11:27 AM
|
#2 |
|
Registered User
Join Date: Sep 2016
Location: Lexington, Ky
Posts: 71
|
Re: 69/70 hood emblem
Bump
Posted via Mobile Device |
|
|
|
|
08-22-2018, 12:09 PM
|
#3 |
|
Registered User
 
Join Date: Mar 2005
Location: Jurupa Valley, Ca
Posts: 1,210
|
Re: 69/70 hood emblem
Ill measure for you when I get home tonight.
__________________
Terry 1970 Custom Camper/C20 , GM Crate 350/7004R, Dana 60, factory AC |
|
|
|
|
08-22-2018, 02:24 PM
|
#4 |
|
Registered User
Join Date: Jul 2013
Location: LI, NY 11801
Posts: 1,140
|
Re: 69/70 hood emblem
After some exhaustive site searching, I found absolutely nothing for templates!
Did you call all the body suppliers? Someone must have it. Bill
__________________
1970 C10 8' Fleetside, L6 250, 3 on the Tree. The most basic of pickup trucks! |
|
|
|
|
08-22-2018, 04:17 PM
|
#5 | |
|
Registered User
Join Date: Apr 2012
Location: Ocala,Fl
Posts: 733
|
Re: 69/70 hood emblem
Check this out, tape on verticals is hooked on lip.
__________________
._____________ ..\ .___ . . . . _ . .\. . . . . . . . . . . ___ ..| /_+_/ ___ |o| ...}. . . . . ______i__!\____ . [_____(O)_|_'|__}>-------[-_(O)__i'___i (O)-] Quote:
|
|
|
|
|
|
08-22-2018, 05:45 PM
|
#6 |
|
Registered User
Join Date: Sep 2016
Location: Lexington, Ky
Posts: 71
|
Re: 69/70 hood emblem
Thank you. I have looked and looked and came up with nada.
Posted via Mobile Device |
|
|
|
|
08-22-2018, 11:55 PM
|
#7 |
|
Registered User
Join Date: Mar 2005
Location: Jurupa Valley, Ca
Posts: 1,210
|
Re: 69/70 hood emblem
I also measured, but from the top edge of the hood. the higher driver side hole is 2.55 inches down, the passenger side is 3.95" down. The driver side hole from the closest edge of the center body line is 1.10" to the right same measurement for the other side. All measurements are to the center of the hole. Hopefully this matches up with the other measurements posted above. I would make a paper template and double check all with the actual hood emblem prior to drilling holes. Always better to measure twice, three times before cutting or in this case drilling
__________________
Terry 1970 Custom Camper/C20 , GM Crate 350/7004R, Dana 60, factory AC |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
