KY Radiator Associated Parts, e.g.saddles

[aotte1]

For sale V8 3 core radiator associated parts. Top radiator hold down bracket, lower radiator saddles, and side baffles. The lower saddles are a little bent.
$100.00 for three items, plus shipping.

Les

[66K20]

Any chance you would sell the 'Top radiator hold down bracket' separately?

[yelmer]

i would be interested in the baffles are they rust free? not bent?

[aotte1]

66K20,
Yes will sell the top radiator hold down bracket.
$40.00 plus shipping.


Les

[66K20]

Originally Posted by aotte1

66K20,
Yes will sell the top radiator hold down bracket.
$40.00 plus shipping.

Sounds good, I'll take it!

[LostMy65]

Originally Posted by aotte1

Are saddle rivets in center or offset. If offset interested. Can you post photo of saddle rivets straight down on them.

Thanks,
Les

What's the position of the rivets have to do with?

[aotte1]

From the position of the rivet, you can tell if the saddle is for a 3 or 4 row radiator. The three row has the rivet in the center of the bottom, and the 4 row has the rivet offset. The photos below show the difference.
1&2). Photos 1 and 2 show a 3 and 4 row bottom saddle for comparison. The 4 row is on left, in both photos. And illustrates on 4 row saddles the rivet is offset. Showing rivet position from top is easy way determine 3 vs 4 row bottom radiator saddle. Without measuring device.
3). Shows two 4 row saddles.
4&5). Photos 4 and 5 show the top radiator hold down bracket. A little additional information. In photo3 you see that the same bottom 4 row saddles, were used to make the top radiator hold down bracket (4 row). Photo 4 shows the radiator hold down bracket from the top, with part of the saddle rivet holes showing. An easy way to identify 4 row top hold down bracket, with out measuring device. 3 row top brackets do not have this hole.

Note: the 3 row saddle is a little bent and may not look lined up 4 row. It is lined up at the bottom. I do not know why the top bracket, 4 rows retain rivet hole, and 3 rows do not. Possibly a welding issue attaching the two parts.

Les

[LostMy65]

Thanks.
I'll take a look at the three I have tomorrow.