|
01-10-2020, 01:59 AM
|
#2 |
|
Senior Member
 Join Date: Mar 2003
Location: Colfax-California
Posts: 8,944
|
Re: Dana 60 Pinion Seal
Nothing special--remove the nut, pull the yoke (probably with a puller if ti is sealed correctly). Remove seal, install new seal.
Hint: when installing the new seal use a bearing race 603010 (I think) after you put some grease on the spring to keep it from bouncing off when you pound the seal in. Install yoke and torque a new nut to about 150 ish. Don't worry about the preload as it has shims not a crush sleeve |
|
|
| Bookmarks |
|
|
Threaded Mode