NiCopp brake lines

[slammed57]

thanks for the info.... iam goin to go with nicopp as well

[KMC3420]

Originally Posted by slammed57

thanks for the info.... iam goin to go with nicopp as well

With the NiCopp lines I actually enjoyed bending/flaring them just a little bit. I think you will as well.

[lux]

Originally Posted by KMC3420

With the NiCopp lines I actually enjoyed bending/flaring them just a little bit. I think you will as well.

I'm told that bending is easy with NiCopp. Did you use a bending tool or just do it by hand?

[KMC3420]

Originally Posted by lux

I'm told that bending is easy with NiCopp. Did you use a bending tool or just do it by hand?

Bending by hand would be easy, however I used a tool to bend for a cleaner look. I also used an angle finder, and cut a 4” piece, marked where my tool would line up, and used that piece to mark my finished line.
Brake line bending tip

[lux]

Originally Posted by KMC3420

Bending by hand would be easy, however I used a tool to bend for a cleaner look. I also used an angle finder, and cut a 4” piece, marked where my tool would line up, and used that piece to mark my finished line.
Brake line bending tip

Thanks for the link. That make a lot of simple sense.

[KMC3420]

Originally Posted by lux

Thanks for the link. That make a lot of simple sense.

Agreed, I didn’t come up with it but it truly does help when you are following a straight line such as an axle or crossmember.