Aisin AR5 Transmission Swap

[Markuli]

Originally Posted by LockDoc

My Novak kit came with a replacement front bearing retainer that accepted the Chevy throwout bearing. For the '34 I used the stock Chevy clutch parts and a T-Bird cable actuator for the clutch fork to pedal. In a '67-'72 Truck you should be able to use all of the stock clutch linkage with the Novak kit.

LockDoc

So my current throwout bearing can be used, that's good to know. I think this is just more of a lack of basic general clutch knowledge on my end, but will my throwout bearing pose an issue if there's an extra 3/8" it needs to travel, since the trans will be 3/8" further from the clutch fingers?