Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
09-13-2021, 09:21 AM | #1 |
Registered User
Join Date: Jan 2011
Location: Redmond, WA
Posts: 82
|
Oil pressure gauge noisy and bouncing after ls swap
The gauge makes a rubbing noise and bounces up towards the high part of the gauge. I replaced the gauge with a used unit and it’s the same thing. Anyone else seen this? Do I just need a new one, perhaps calibrated for higher pressures? I was going to hook up a cheap mechanical and see how it behaves.
|
09-13-2021, 09:42 AM | #2 | |
The Older Generation
Join Date: Aug 2006
Location: Montezuma, Iowa
Posts: 25,769
|
Re: Oil pressure gauge noisy and bouncing after ls swap
Quote:
My stock gauge works fine with the LS1 in my '67 Panel Truck. I drilled & tapped the stock sender housing for the line. I am going to move this to the "LSx Swaps" forum. LockDoc
__________________
Leon Locksmith, Specializing In Antique Trucks, Automobiles, & Motorcycles (My Dually Pickup Project Thread) http://67-72chevytrucks.com/vboard/s...d.php?t=829820 - |
|
09-13-2021, 10:19 AM | #3 |
Registered User
Join Date: Dec 2009
Location: Independence Mo
Posts: 4,118
|
Re: Oil pressure gauge noisy and bouncing after ls swap
The gauge in my green truck doesn't make any noise, that I can hear anyway, but it does bounce when the engine is warm. Been doing that for the last 54k miles that it's been in the truck, so I don't worry about it.
__________________
My '72 short bed build. http://www.ls1tech.com/forums/conver...6-0-4l80e.html 5.3 swap into my RUSTY '71 C10 http://ls1tech.com/forums/conversion...71-c-10-a.html |
09-13-2021, 11:22 AM | #4 |
Registered User
Join Date: Nov 2014
Location: Austin
Posts: 749
|
Re: Oil pressure gauge noisy and bouncing after ls swap
The stock gauge in my '71 works perfectly. With the 1st LS that had oil pressure issues, the gauge would bounce when oil warm/hot and pressure was low (about 1/4 on the scale) at idle.
The replacement LS (without oil pressure issues) the gauge works perfectly. A bit above 3/4 when cold and a bit above 1/2 when warm/hot both at idle. No bouncing of the needle. |
09-13-2021, 04:12 PM | #5 |
Registered User
Join Date: Jan 2011
Location: Redmond, WA
Posts: 82
|
Re: Oil pressure gauge noisy and bouncing after ls swap
Thanks for responses. Maybe I just need to order a new one. It’s the metal rubbing sound that’s more annoying than the bouncing.
|
09-14-2021, 01:21 AM | #6 |
Registered User
Join Date: Dec 2017
Location: Elkhart, Texas
Posts: 1,841
|
Re: Oil pressure gauge noisy and bouncing after ls swap
Have you checked the oil pressure using a mechanical test gauge?? It could be the stock gauge is not at fault, but the engine has an actual oil pressure problem.. Perhaps if you locate and repair the erratic oil pressure issue, the noise and bounce will disappear..
|
Bookmarks |
|
|