|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
09-27-2023, 02:15 AM
|
#16 |
|
Senior Member
  
Join Date: Jan 2005
Location: CA
Posts: 7,024
|
Re: Dissembling a tilt column
I have a tilt column to rebuild, so I made a plate that can be slipped into the top of the column for pulling off the cover with a steering wheel puller. The plate has an outer diameter of approximately 3-3/4", although I had to grind it down slowly until it would fit in. The cover came off easily, and there was zero deformation of the lip on the cover.
|
|
|
| Bookmarks |
|
|
Threaded Mode