Control arm shaft torque?

[novaX522]

Originally Posted by MikeB

I forget which manual I used for specs when I did mine years ago, but no way were they the "new" numbers in the chart above. That chart is a bit strange showing the torque for "bushings" when there are no bushings.

Couldn’t agree more Mike. Real confusing. I got the nuts as tight as I could with a 1/2” ratchet. I then used a 3’ long 3/4” torque wrench to check the torque. I was able to get them tight enough with the 1/2” ratchet. I don’t think they are going anywhere.