Let's see your homemade crafts! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**slomotion** · 09-25-2024, 03:13 PM

HO, very nice, clean, fit and finish! The image with the clamps reminded me of the old saw - " If you didn't use all of your clamps, you didn't use enough. If you did use them all you don't have enough."

Ken O, nice looking boats! We don't have many ponds or lakes in this area where we can use IC engines, so most of our builds are electric. There are a couple of brushless screamers though.

I live at the other end of the spectrum with a few slow boats that don't move faster than I can think.

09-25-2024, 03:13 PM	#31
slomotion Old Duffer Join Date: Mar 2003 Location: Maine Posts: 1,854	Re: Let's see your homemade crafts! HO, very nice, clean, fit and finish! The image with the clamps reminded me of the old saw - " If you didn't use all of your clamps, you didn't use enough. If you did use them all you don't have enough." Ken O, nice looking boats! We don't have many ponds or lakes in this area where we can use IC engines, so most of our builds are electric. There are a couple of brushless screamers though. I live at the other end of the spectrum with a few slow boats that don't move faster than I can think. Attached Images __________________ '68 Short C20 Flatbed Dually w/ 292 4bbl, Langdon cast headers, and WC T5 trans. '81 G10 Shorty Van "Good judgement comes from experience, and a lot of that comes from bad judgement." Will Rogers "Under promise, then over achieve."



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.