|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
08-31-2025, 05:36 PM
|
#8 |
|
Registered User
 
Join Date: Jul 2007
Location: Toppenish, WA
Posts: 16,391
|
Re: panel measurement
The lip on the front panel is the thickness of the wood below the angle side rails on the bedsides. That should end up being 5/8 of an inch from the bottom of the angle to the lip.
You probably want to measure from the center of matching bolt holes on the bedside and the panel to figure out where that lip goes. Then it will take having a 50 inch strip of correct thickness sheet metal bent in a brake and fit the two These are the bed wood dimensions from GMC pauls site. tog  ether and weld up. 
__________________
Founding member of the too many projects, too little time and money club. My ongoing truck projects: 48 Chev 3100 that will run a 292 Six. 71 GMC 2500 that is getting a Cad 500 transplant. 77 C 30 dualie, 454, 4 speed with a 10 foot flatbed and hoist. It does the heavy work and hauls the projects around. Last edited by mr48chev; 08-31-2025 at 05:43 PM. |
|
|
| Bookmarks |
|
|
Threaded Mode