|
01-09-2008, 04:09 PM
|
#1 |
|
Registered User
Join Date: Jan 2008
Location: laurens S.C
Posts: 10
|
Drip Molding
i just cleaned up the drip molding on my cab can anyone tell me what to seal it whit
|
|
|
|
01-09-2008, 11:18 PM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Drip Molding
There are a few products available and preparation is very important.
Here is a link to an article on seam sealing and it compares different products as well as application techniques. http://autobodystore.com/forum/showthread.php?t=7467 I used 3M's "Ultrapro" on the last cab that I did and so far it is holding up well. Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
01-12-2008, 04:43 AM
|
#3 |
|
Registered User
Join Date: Jun 2001
Location: Gainesville, GA
Posts: 823
|
Re: Drip Molding
The 3M self leveling is what I prefer.
__________________
'52 Buick Special Dlx 2dr. sedan, '68 Camaro '69 C-10 Panel, '07 Toyota Taco SR-5 "Try to be the person your dog THINKS you are" |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
