|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-12-2011, 02:32 PM
|
#1 |
|
Registered User
Join Date: Feb 2008
Location: Surprise, Ariz.
Posts: 186
|
starter sol 73gmc 350v
Hi all, i am starting the engine with an acutron remote hookup. The engine starts but the solenoid doesn't disengage. A loud noise comes from the starter area. Is the starter bad. Up to now never has been used. the starter w/solenoid was purchased on amazon new. Please advise. Thanks, Frank 73oldie.
|
|
|
|
07-12-2011, 09:28 PM
|
#2 |
|
Robert Olson Transport
 
Join Date: Oct 2002
Location: recent transplant to NC USA
Posts: 20,300
|
Re: starter sol 73gmc 350v
if the starter didnt disengage you should prolly remove it and bench test it to see if its bad
__________________
Bob 1951 International running on a squarebody chassis "If a man's worth is judged by the people he associates himself with, then i am the richest man in the world knowing some of the fine people of this board" http://67-72chevytrucks.com/vboard/a...t.php?f=25&a=9 (you can review the site rules here!) PM Me for your vehicle/parts hauling needs in the North East US or see my Facebook page Robert Olson Transport Live each day to the fullest.. you never know when fate is going to pull the rug out from under you... I hate cancer!! |
|
|
|
|
07-13-2011, 03:12 PM
|
#3 |
|
Registered User
Join Date: Feb 2008
Location: Surprise, Ariz.
Posts: 186
|
Re: starter sol 73gmc 350v
Hi Rusty, I seemed to have found the problem. I had an exitor wire wired to the solenoid post. After i removed the wire the solenoid disengaged. Ths exitor wire according to Ezwiring should go to the ignition. Then from ignition to the s post. Now i have to figure that hookup. Am restoring this truck. Thanks for the help, i submitted a new problem thread today. Frank thanks again.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
