|
05-01-2019, 09:51 PM
|
#1 |
|
Registered User
Join Date: Jul 2017
Location: Downers Grove, IL
Posts: 205
|
Warp in door panel
I'm thinking about repainting my door panels. Each of the door panels has a warped area, perhaps from being in the Nevada heat for 40 years. Can this be fixed? Any thoughts?
|
|
|
|
05-02-2019, 02:54 AM
|
#2 |
|
Registered User
Join Date: Nov 2011
Location: Sheffield, ALA
Posts: 2,471
|
Re: Warp in door panel
Maybe it could be heated up and flattened back out. Take a heat gun and warm it up and set a couple blocks on it and see if that does the trick.
|
|
|
|
|
05-02-2019, 05:38 PM
|
#3 |
|
Senior Member
 
Join Date: Dec 2014
Location: Edmonton Alberta
Posts: 1,457
|
Re: Warp in door panel
I just tried the heat gun on my own, it just made it worse. I would try to make a form for it to press into if I were to do it again. Good luck, though.
__________________
DAVE Edmonton, Alberta 1959 Apache 1967 K20 1968 C20 1970 C10 1972 GMC 2500 1981 C10 |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
