|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-18-2023, 03:25 PM
|
#1 |
|
Registered User
Join Date: Nov 2018
Location: Huntsville, AL
Posts: 339
|
O-rings for factory hubs
Hey, does anyone have part number for the two o-rings required inside the factory locking hub assembly? Thanks!
|
|
|
|
01-18-2023, 09:00 PM
|
#2 |
|
Senior Member
 
Join Date: Jul 2001
Location: Wellington, Ks
Posts: 10,294
|
Re: O-rings for factory hubs
Following along on this, would be good to know.
__________________
1971 Chevy 1/2T 4x4 LWB 350 V-8 Was sm465-now 350TH/np205 Tilt, Tach, Towhooks Original Truck AM/FM Wellington, Ks |
|
|
|
|
01-18-2023, 09:55 PM
|
#3 |
|
Senior Member
Join Date: Nov 2012
Location: Southeast Michigan
Posts: 792
|
Re: O-rings for factory hubs
I have some from rebuilding a '65 C10. Had to buy a bunch to get what I needed so I have a lot left over. If what you need is the same, then I can put together "kits".
|
|
|
|
|
01-21-2023, 12:20 PM
|
#4 |
|
Senior Member
Join Date: Jan 2004
Location: Olathe KS (Greater Kansas City MO Area)
Posts: 2,051
|
Re: O-rings for factory hubs
www.torqueking.com - #'S
QU40044 - Hub O-Ring / Hub Dial O-Ring for Dana Internal Spline QU40045 - Hub Cap O-Ring / Hub Cap (Hub Body) O-Ring |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
