Grease upper balljoint on 4x4

[LONGHAIR]

Originally Posted by hatzie

Try one of these with the U-Joint turned to the right position...

Those require a specific fitting, not the typical zerk.

[hatzie]

Originally Posted by LONGHAIR

Those require a specific fitting, not the typical zerk.

I've used one on straight zerks that were difficult to reach at best. Dirty grease squirted out around the unsealed shaft away from the zerk so it was feeding through and not just making a mess at the zerk. It wasn't a super tight seal though.
I'd be interested to see the fitting they were actually made for. If it's low enough profile it might be worth changing to... in places like the upper Ball Joint on the Dana44 and down those nasty holes on the baler and the chopper... If I can reach em to swap em out.

[kikkegek]

Originally Posted by hatzie

I'd be interested to see the fitting they were actually made for.

I posted it in one of my previous posts: