|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-10-2023, 08:31 PM
|
#12 |
|
Registered User
Join Date: May 2012
Location: Scottsdale, AZ
Posts: 1,921
|
Re: Dana 44 Closed Knuckle Axle Shaft U-Joint Part Number
The inner on my driver side got to the point where I couldn't ignore it anymore. So I did axle upgrades and the inner seals last summer. I used the seal install tool, made it a bit easier. I replaced all the shafts, bearings and hubs ect... while I was at it. I just did a quick sanity check with the dial indicator before I closed it up. I checked it before I dropped it out and no change.
 j
__________________
White K20 |
|
|
| Bookmarks |
|
|
Threaded Mode