Dana 44 Closed Knuckle Axle Shaft U-Joint Part Number

[Chaparralman1974]

Originally Posted by jeffahart

The inner on my driver side got to the point where I couldn't ignore it anymore. So I did axle upgrades and the inner seals last summer. I used the seal install tool, made it a bit easier. I replaced all the shafts, bearings and hubs ect... while I was at it. I just did a quick sanity check with the dial indicator before I closed it up. I checked it before I dropped it out and no change.

j

I have tore the entire axle down and removed the ring and pinion. My plan is to replace all the seals, clean and paint everything. I also picked up the seal installation tool. They are cheap enough rather than trying to beat the seal into place. I am also planning on replacing both U-Joints. Fortunately, all of the bearings are in excellent condition, so I can reuse those. I am also going to swap over the Spicer big hubs to the closed knuckle axle as well. I did end up cleaning the original Hub-Loks and I will keep them around for giggles, but I think that the Spicer hubs just look cooler. :-)


Clay